How to remove the fuse from the breech of the gun - Genshin Impact

Genshin Impact Update 2.6 added a completely new region called The Chasm to the game, and the world quests The Heavenly Stone’s Debris appeared with it, in which the player explores caves to find out ancient secrets hiding deep inside. In one of these quests, the player needs to remove the fuse from the gun to destroy a boulder that blocks part of the abyss.

• How to remove the fuse from the official part of the gun?
• How to change the frequency of a lamppost to remove the fuse from the official part of the gun?

In this quest, Jinu gives the player several tasks, and Clitofo, Zhitsyun and Pacemon will be your guides. Further along the way, you will also need to charge a gun with your companion to shoot from it. However, before doing this, you need to unlock the fuse located on the breech of the gun.

How to remove the fuse from the official part of the gun?

After you follow the marker and get to the quest area, you will come across a table with a book, which is a guide to alarm the safe explosive device. When interacting with it, you will receive a set of instructions, which indicates what frequency each lamppost flashes. In total, there are three lampposts that you can observe: a high lamppost, an average lamppost and a low lamppost. The frequency with which each of these lampposts should flash is as follows:

High lamppost: low frequency * Average lamppost: low frequency Low lamp pillar: High frequency

After you read the leadership and recorded the instructions, head to the luminous point at the edge of the platform. From here you can observe what three lamps should be turned on, indicated by luminous light. Since the platform is higher than three lampposts, we will start with a high lamppost, then the middle lamppost and, finally, a low lamppost.

How to change the frequency of a lamppost to remove the fuse from the official part of the gun?

To change the frequency of a lamppost, we first need to activate it. Then interact with it again to change the frequency. High -frequency flicker Once per second at the same time low -frequency flicker Once every two seconds .

To begin with, just slide down from the platform K High lamppost . After activation, make sure that it is installed on low frequency . Then go to the average lamppost as shown from the observation point, and install it on low frequency . For the latter, you need to go a short distance on foot towards the noted low lamelled pillar . Activate it and set high frequency . There will be enemies in this area, so act carefully.

After turning on all three lampposts and the corresponding frequency settings, the quest will be completed, and you can start loading a cannon core with a chiz.

Have you found good, floating in the abyss? Check out all the locations of good in The Chasm in Genshin Impact right here in professional game guides.